Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
dlevasseur
Contributor
Contributor
‎03-21-2018 03:02 PM

Netvanta 1234 POE Slow access / inaccessible

Recently ended up with one of these used.  I did the full factory reset via CLI and enabled the GUI interface and also the FTP server to upload the current firmware.  Only my laptop is connected to it via ethernet.  The GUI interface is extremely slow and times out.  When it does load most of the images and buttons do not load.  So I tried to access via FTP to install the current firmware and while my FTP client does connect to it, I never get a username request and eventually a connection time out.

Maybe it's just shot and I should toss it?

Labels (1)
0 Kudos
Reply
2 Replies
jayh
Honored Contributor
Honored Contributor
‎03-22-2018 06:38 PM

Re: Netvanta 1234 POE Slow access / inaccessible

I would attempt to upgrade the firmware either from the GUI or via TFTP before writing it off. Note that there are three hardware generations of the Netvanta 1234. Check the full part number of your device to be sure you are uploading the correct firmware for your hardware.

0 Kudos
Accept as Solution Reply
Anonymous
Not applicable
‎03-29-2018 11:49 AM

Re: Netvanta 1234 POE Slow access / inaccessible

Also double check the port configurations and verify the port your laptop is plugged into is set to auto negotiate.  If you are getting a duplex mismatch between the lap top and the switch port that can cause you are describing.

John W.

0 Kudos
Accept as Solution Reply