The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
dayatkins
New Contributor

AdTran 3120 Firmware Disaster

I have installed the latest firmware on my AdTran 3120 but upon reboot now get the following error: 

adtran netvanta 3120 typeerror: group.links(selldx) is undefined.

My menu has disappeared so I cannot navigate to restore older firmware.  Any guidance is appreciated.

0 Kudos
1 Reply

Re: AdTran 3120 Firmware Disaster

This could be due to a corrupt firmware.  I should re-download the firmware to start with (I hope one day Adtran provide MD5 or SHA checksums to save us from problems like this).  Then you will need to reset the router and place it into Bootstrap mode:

Power off the router.  Power it on and imediately press the Reset button and hold it depressed.  Eventually the STAT light will stop flashing and will remain alight.  You should be able to access the router on IP address 10.10.10.1.  Set up a static IP on your PC to be able to connect to the router using telnet.  Then get a TFTP server running on your local PC and make sure that it is not being blocked by the PC's firewall.

Once connected to the router see if you can list the filesystem:

Bootstrap# show flash

If you can see the firmware you uploaded, try to delete it:

Bootstrap# erase file_name.biz

Alternatively, you can erase everything on the Flash drive:

Bootstrap# erase file-system

Note:  If you do not have a backup of your configuration and want to try to back it up BEFORE you delete the whole filesystem, you can try:

Bootstrap# startup-config tftp

Address of remotehost? 10.10.10.10 (or whatever your TFTP server is running on)

Destination filename? backup_config

Then proceed to upload the fresh copy of the firwmare you have just downloaded.

Bootstrap# copy tftp flash

Address of remotehost? 10.10.10.10

Source filename? file_name.biz (use the name of the firmware you want to upload)

Then be patient and do not disrupt the upload.  Eventually it will finish.  Then set it up so that the router boots from it:

Bootstrap# boot system flash file_name.biz

Bootstrap# boot

Hopefully the router will reboot fine with the new firmware.  In case the configuration file is also corrupt, you can press the reset button before you replace the firmware and check if it will boot normally with default settings.

If neither the firmware, nor the configuration caused this problem, something could be wrong with your boot code or hardware - contact Adtran for advice/replacement/repair.

Hope this helps.

--

Regards,

Mick