I've got a TA904 running T900G2A-A5-03-00-E.biz that spits out the following error message when you call a SIP account that's connected to FXS0/1.
2012.12.03 14:29:03 SB.CALL 20 RTP resource unavailable or SDP negotiation failed. Call from (42366xxxxx) to (42383xxxxxx).
When I use the command "sh ver" the output detailing the DSP is missing. Does that mean I've got a bad DSP? Are there any DSP related debug commands I should try?
ADTRAN, Inc. OS version A5.03.00.E
Mainline Version: M04
Checksum: 80DBF88B
Built on: Fri May 11 14:24:12 2012
Upgrade key: cffba73490ae99efa483f0449sdfcc97
Hardware version DSP7119-2ndGen
Boot ROM version 14.04.00
Checksum: 8549
Built on: Wed Apr 11 15:24:20 2007
Copyright (c) 1999-2007, ADTRAN, Inc.
Platform: Total Access 904 (2nd Gen), part number 4212904L1
Serial number CFG0xxxxxx
Flash: 33554432 bytes DRAM: 67108863 bytes
customer-324234 uptime is 0 days, 0 hours, 31 minutes, 53 seconds
System returned to ROM by Warm Start
Current system image file is "T900G2A-A5-03-00-E.biz"
Primary boot system image file is "T900G2A-A5-03-00-E.biz"
Backup boot system image file is "T900G2A-A4-02-00-E.biz"
Primary system configuration file is "startup-config"
It looks like the DSP is bad. In the past I have tried to erase the config and re-flash firmware with limited success. You can certainly try these steps. If nothing helps, you can contact Tech Support.
Regards,
Geoff
Please post the output of “show version”
If it doesn’t show something similar to the output below you have a bad DSP.
slot 0, DSP 1
DSP software version: G1.A4.00.31
DSP hardware version: Freescale MSC7116
Total channels: 24
I hate to sound like a jerk but did you not read my entire post that included a "sh ver" ?
It looks like the DSP is bad. In the past I have tried to erase the config and re-flash firmware with limited success. You can certainly try these steps. If nothing helps, you can contact Tech Support.
Regards,
Geoff