cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
fiberman
New Contributor III

Show MAC Address Command

Jump to solution

What command can be used to show the MAC address of a TA 908e unit? I think you are able to see the MAC address in the web interface, but I need to do it by command line.

0 Kudos
1 Solution

Accepted Solutions
Anonymous
Not applicable

Re: Show MAC Address Command

Jump to solution

Hello fiberman,

The command: show interface ethernet 0/1 will output the mac/hardware address:

TA924e#show int eth 0/1

eth 0/1 is UP, line protocol is UP

Hardware address is 00:A0:C8:36:32:0C

  Ip address is 10.100.101.2, netmask is 255.255.255.252

  IP MTU is 1500 bytes

  BW is 100000 Kbit

The same command is valid for eth 0/2.  Let us know if you have any questions.

Regards,

Geoff

View solution in original post

0 Kudos
3 Replies
Anonymous
Not applicable

Re: Show MAC Address Command

Jump to solution

Hello fiberman,

The command: show interface ethernet 0/1 will output the mac/hardware address:

TA924e#show int eth 0/1

eth 0/1 is UP, line protocol is UP

Hardware address is 00:A0:C8:36:32:0C

  Ip address is 10.100.101.2, netmask is 255.255.255.252

  IP MTU is 1500 bytes

  BW is 100000 Kbit

The same command is valid for eth 0/2.  Let us know if you have any questions.

Regards,

Geoff

View solution in original post

0 Kudos
Anonymous
Not applicable

Re: Show MAC Address Command

Jump to solution

Hello,

I went ahead and flagged this post as "Correct."  If you still need assistance, we would be more than happy to continue working with you on this - just let us know in a reply.

Thanks,

Geoff

askthecableguy
New Contributor

Re: Show MAC Address Command

Jump to solution

What would the command be to locate the Chassis MAC address. For inventory purposes my employer uses the chassis MAC address, but sometime uses the 1st Hardware MAC on the device. I can see the Hardware MAC, but not the Chassis MAC.