![](/skins/images/87260258FEE5B17A85B3965E6BCC7928/responsive_peak/images/icon_anonymous_message.png)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a BSAP-1920 that is connected to an Adtran 1538 switch, and being configured via an off site controller. The switch is set to auto negotiate, and when the switch and access point are rebooted, they only negotiate to 100/Full never to 1G/Full. When the switch is set to 1G/Full, the access point never comes active.
Accepted Solutions
![jayh jayh](https://supportcommunity.adtran.com/legacyfs/online/avatars/a4997_bluebox2.png)
![Honored Contributor Honored Contributor](/html/@A202AF57A7F94E73C594B8BD24E197EC/rank_icons/silver.png)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Not the Solution
- Report Inappropriate Content
Check the cable including patch panels and jumpers between the AP and the switch. In some cases only two pair are wired to save cost. This works for 100Mbps connections but gigabit requires all four pairs.
![jayh jayh](https://supportcommunity.adtran.com/legacyfs/online/avatars/a4997_bluebox2.png)
![Honored Contributor Honored Contributor](/html/@A202AF57A7F94E73C594B8BD24E197EC/rank_icons/silver.png)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Not the Solution
- Report Inappropriate Content
Check the cable including patch panels and jumpers between the AP and the switch. In some cases only two pair are wired to save cost. This works for 100Mbps connections but gigabit requires all four pairs.
![](/skins/images/87260258FEE5B17A85B3965E6BCC7928/responsive_peak/images/icon_anonymous_message.png)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Accept as Solution
- Report Inappropriate Content
Re: BSAP-1920 won't auto negotiate to 1G
Test your AP cable Ethernet link with a device that you know will negotiate to 1G, such as a laptop.
![](/skins/images/87260258FEE5B17A85B3965E6BCC7928/responsive_peak/images/icon_anonymous_message.png)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Accept as Solution
- Report Inappropriate Content
Re: BSAP-1920 won't auto negotiate to 1G
Seems the cable tester wasn't used on this run, open connection..