cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
normrr
New Contributor III

904 2nd Gen-outbound caller ID

I ran into an issue the other day with an older PBX, it could not send a BTN or id on an outbound call. My soft switch needs to see an ID to route the call, I worked with the Vendor to cobble something together. My question is will the 904 2nd Gen allow me to set an out bound Id so that every call will show the ID at the soft switch. I read the Doc's on the 904 and set an ID for the .

Labels (2)
4 Replies
Anonymous
Not applicable

Re: 904 2nd Gen-outbound caller ID

Hi normrr:

Maybe try one of the following on the trunk that faces the soft switch:

!

voice trunk T01 type sip

  match ani $ add p-asserted-identity 2605551212

  match ani $ replace diversion 2605551212

!


Best,

Chris

normrr
New Contributor III

Re: 904 2nd Gen-outbound caller ID

Thanks cj!, I will try them.

normrr
New Contributor III

Re: 904 2nd Gen-outbound caller ID

Looks like it might not be an outbound ANI issue but a setup message issue btween the PBX and the ADTRAN/softswitch. I will pull some logs and maybe ask for more help.

sipjunky
New Contributor II

Re: 904 2nd Gen-outbound caller ID

I found this Adtran PDF very useful for adding headers or changing headers from PRI to SIP so the SBC would be satisfied.

Manipulating SIP Headers and Messages in AOS

https://supportforums.adtran.com/servlet/JiveServlet/previewBody/5041-102-2-5478/6AOSCG0026-29A.pdf